Standing seam and metal panel roofing, roof repair and full replacement in Aurora. We show up when we say we will, and we clean up before we go.
Everything we do on a roof, done by crews who have been doing it the same careful way since 2002.
Reflective coatings keep a metal roof cooler in summer and seal up the small stuff before it turns into a leak.
Metal, shingle and low slope work on buildings where a leak costs you more than a wet ceiling. Free estimates, same as anywhere else.
Water runs along decking and rafters before it ever drips, so the stain is rarely under the hole. We trace the leak back to where it really starts and fix that.
Full tear off, decking checked board by board, then a new metal or shingle roof over proper underlayment. You get the price and the start date before anything comes off.
A careful walk over the whole roof — panels, shingles, valleys, flashing, fasteners — plus the attic side when there is a way in. You get photos and a straight answer.
Rotted fascia and sagging soffit let water and animals in behind the roof edge. We cut the bad wood out and put new in.
Guards installed as part of a roof job or on their own. Either way we check the hangers and the pitch while we are up there.
Old skylights leak at the flashing long before the glass ever fails. We reflash, reseal, or set a new unit and tie it in properly.
This is the work our name is attached to. Two decades of tin roofs on houses, churches, barns and additions, installed by crews who cut the trim on site instead of forcing something that almost fits.
Missing shingles get matched as close as weathering allows. Loose metal gets new fasteners and washers, and the eaves, rakes and ridge get sealed back up tight.
Porch roofs, additions and low slope sections that hold water instead of shedding it. We rework the flashing, seal the seams, and get water moving again.
Repair or replace, we handle both, and we work from what the roof actually needs rather than from what an adjuster might approve.
We repair standing seam, exposed fastener panels and metal shingles, and we match the color as closely as the paint system will allow.
Removing the ice is the easy half. We also look at ventilation and insulation so it stops happening every January.
We still shingle plenty of roofs. Cracked, curled and blown off shingles get replaced, and the valleys and flashing get reworked while we are up there.
Waterproofing details on additions, porches and low slope tie ins, where two roofs meet and most leaks quietly begin.
After a storm we walk the roof, photograph everything we find, and write an itemized estimate you can hand straight to your adjuster.
Temporary cover goes on fast, then we come back and make the permanent repair once we can see properly what we are working with.
Slate and tile take patience and matching pieces. We replace broken and slipped units and rework the flashing they hide.
Lifted panels, missing shingles, flashing that has given up where the chimney comes through. We find what is actually wrong, fix that, and leave the rest of your roof alone.
Metal is what we are known for. Since 2002 the bulk of our work has been standing seam and metal panel roofs, and it is still what most Aurora homeowners call us about. We measure on site, help you settle on a color, and set the panels straight.
We do shingle roofs too, and plenty of them. But if you have been thinking about a tin roof on your Aurora home, that is the conversation we enjoy most — panel type, color, trim, and what it is really going to cost.
Why people around Aurora call us back and send their neighbors our way.
The same family started this company putting metal roofs on neighbors houses in 2002. It has never been sold, franchised or handed off to a call center.
You get a start date and we hold to it. If weather moves your job we call you, rather than leaving you watching the driveway.
Standing seam and metal panel roofs are the work we are known for. Color, trim, fastening pattern — we have done hundreds and we will walk you through all of it.
Somebody comes out, measures, gets on the roof, and leaves you a written price. No charge, no obligation, and no number that expires if you do not sign today.
If your roof needs a repair and not a replacement, we say so. Plenty of our best customers are people we talked out of a job they did not need yet.
Straight answers to what Aurora homeowners ask us most often.
Often, yes. Plenty of the Aurora roofs we get called to look at need flashing reworked or a section refastened, not a whole new roof. We will tell you honestly which one you are looking at, and if it is repairable we would rather repair it.
A typical Aurora shingle roof runs roughly $8,000 to $18,000 in 2026 for an average single family home, and more if the deck has rot or the roof is steep and cut up with dormers. We do not price off a satellite photo — somebody comes out and measures.
Most Aurora metal roof jobs land somewhere between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off there is. Standing seam runs higher than exposed fastener panels. We measure before we quote, and the estimate is free.
Most Aurora houses are a two to four day job. A straightforward shingle roof can be done in a day or two. A cut up metal roof takes longer because every panel, valley and trim piece is measured and fit on site rather than pulled out of a box.
We do. After a storm we photograph the damage on your Aurora roof and write an itemized estimate you can hand to your adjuster. We do not file the claim for you and we will not promise you what an adjuster is going to approve — that is their call, not ours.
Much less than people expect. Over solid decking with underlayment under it, a Aurora metal roof sounds about like a shingle roof from inside the house. The loud tin roof people remember was screwed straight to open purlins over a barn with nothing underneath.
Real feedback from homeowners whose roofs we have worked on.
"Twenty year old tin roof with screws backing out everywhere. They refastened the whole thing with new washers instead of talking me into a replacement I did not need."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"Wind peeled up the edge of our roof and they came out that same evening to cover it so the rain would not get in. Permanent repair the following week."
Our crews cover the surrounding area, not only the city limits.